Skip to content

Free in-person consultation, every cost on paper: (972) 472-2172

Mesquite · Balch Springs · Sunnyvale · Forney

(972) 472-2172

ServicesEntry Doors

Entry Door Replacement in Mesquite

Over the years a front door gets slammed, kicked shut, baked by sun and soaked by storms. We swap worn, drafty or dented entry doors for new prehung units, set square and sealed tight. Before any work begins, you get the full scope and price on paper.

Two installers seen from behind carry a dark entry door with decorative glass sidelites into the front doorway of a brick house, a ladder and tool bag nearby

When a New Entry Door Makes Sense

An entry door is more than a slab on hinges. It is the frame, the threshold, the weatherstrip, the lock and the seal around it, all working together. When one piece goes, the others usually follow. A door that drags, leaks air or won't latch is often telling you the whole unit is done.

We install complete prehung doors, so the slab, frame and threshold come from the factory already matched. That gives you a door that closes clean and seals all the way around, instead of a new slab fighting an old, worn frame.

Before we order anything, we measure the opening, check the framing and walk you through the choices. Then we put it in writing: the door, the glass, the hardware, the trim work and the cleanup. If something under the old threshold turns out worse than expected, we show you and talk it over before any change to the price.

Worker in a navy polo and cap writes on a clipboard beside a worn sliding patio door on a wooden back deck of a brick house, with tools and a ladder nearby

What Comes With Your New Door

  1. 01

    Removal and haul-away

    We take out the old door, frame and threshold and take them with us. Nothing gets left at the curb.

  2. 02

    A prehung unit sized to your opening

    Steel, fiberglass or wood, in a size matched to your measured opening. We can include sidelights or a transom if your home has them or you want to add light.

  3. 03

    Sill pan and flashing

    The bottom of the opening is where water does its damage. We set a sill pan and flash the sides so rain that gets past the door has a way out instead of soaking the subfloor.

  4. 04

    Shimmed, square and foamed

    We shim the frame plumb and level, run long screws through the hinges into the framing, and fill the gap with low-expansion foam. That keeps the door from sagging and stops drafts at the edges.

  5. 05

    Locks and hardware

    We install the handle set and deadbolt, with strike plates screwed deep into the framing. If you want it, we can key the new lock to match your other doors.

  6. 06

    Trim and final seal

    Interior casing goes back on, the outside gets caulked, and we sweep up before we leave.

Questions about Entry Doors?

Call(972) 472-2172

Signs Your Entry Door Is Worn Out

  • Light showing at the edges

    Stand inside with the lights off on a sunny afternoon. A glow at the top corners or under the slab means air and dust are coming in as well. Weatherstrip on an old, shifted frame rarely seals well again.

  • It sticks or won't latch

    Doors that drag on the threshold or need a shoulder to close have usually shifted. The shrink and swell of the clay soil around the Dallas area moves houses, and older frames can't take up the difference.

  • Soft wood at the bottom

    Press on the frame near the threshold. If it feels spongy or flakes, water has been getting in for a while.

  • Dents, rust or a warped slab

    Steel doors dent and rust along the bottom edge. Wood doors can bow and crack in the summer sun. Once the slab is out of shape, it won't seal.

  • Fogged glass inserts

    Haze between the panes of a decorative glass insert means the seal has failed. You lose insulation and the view.

How the Job Goes

  1. 1

    Free in-person consultation

    We come out, measure the opening and look at the frame, threshold and floor. You see door samples and we talk through what fits your home and budget.

  2. 2

    Your written quote

    You get a line-by-line breakdown that covers the door, glass, hardware, labor, trim and haul-away. What you sign is what you pay, unless we find hidden damage and you approve the fix.

  3. 3

    Ordering

    After you sign off, we place the order for a door built to your size and options. When it comes in, we call you to pick a date that suits your schedule.

  4. 4

    Install day

    We lay down drop cloths, pull the old unit and set the new one. Your home is open for part of the day, so we keep the work moving and close it up before we leave.

  5. 5

    Final check together

    You swing the door a few times yourself, turn the deadbolt and try every key before we hand them over. If it rubs, sticks or feels off, we adjust it before we pack up.

What Sets the Price of an Entry Door

Every opening is different, so we don't price a door off a photo. Your total depends on two things: the door you pick and the shape the doorway is in once we look at it. Each piece is listed in writing so you can see where the money goes.

Material of the slab
Steel is usually the most budget friendly. Fiberglass costs more but resists dents and holds up well in heat. Solid wood sits at the top and needs more upkeep.
Size and extras
A single standard door is the simplest job. Double doors, sidelights, transoms or a taller custom size add both material and labor.
Glass
A solid slab costs less than one with a full or half glass insert. Decorative, privacy or low-E glass adds to the price.
Hardware and finish
Handle sets, smart locks, multi-point locks and factory paint or stain all change the total. Basic hardware keeps it down.
What's under the old door
Rotted subfloor or framing at the threshold has to be fixed before a new door goes in. We check for it at the consultation and price it up front when we can see it.

Questions About Entry Doors

How much time does a front door install take?

Most single prehung doors take a portion of one day. Sidelights or a transom add time. Your written quote will include an honest time estimate.

Is steel or fiberglass the better choice?

Steel is tough and less expensive, though it can dent and rust along the bottom over the years. Fiberglass stands up better to strong sun and moisture and shrugs off accidental bumps. At the consultation you can handle both and compare.

Can the new lock match the key I already use?

Usually, yes. Mention it during the consultation so we can plan ahead, and have a key ready for us to match.

Do I have to be home while you install?

Please have an adult there when the crew arrives so we can review the plan, and again at the end so you can test the door. In between, go about your day. Since the doorway sits open for part of the job, keep pets in a closed room or away from the house.

Which credentials do you hold?

Our company is AAMA certified, and we carry full insurance during all work at your home.

Can you handle patio and storm doors too?

Yes. A lot of homeowners add a storm door in front of a new entry door for more protection. Patio doors and window replacement are also on our list, and we can quote everything during one visit.

Low-angle view of a two-story brick house with new black-framed windows still bearing stickers, a removed old window, ladder and plywood by the porch

Get a Front Door That Closes Right

We come to your home in Mesquite or a town nearby like Forney, Garland or Rockwall, measure the doorway and leave you a written quote. If the budget is tight, you can use our 0% Financing options or start with $0 Down on the whole project. Nobody pushes you, and nothing shows up later that the quote didn't list.